Teac DA-88 - Manual

DA-88 quick ref.doc
10/14/97
7:27 PM
Page 1
© TEAC America, Inc., 1997 All rights reserved.
BASIC FUNCTIONS Software Version 4.01
Items marked SY are only available when the SY-88 is installed.
Function Display
LED
To Enter Function To Enter
Data
Remarks
1 Display ABS Time ABS Hold DISPLAY + - -
2 Display H:M:S:F TC difference DIFF SY DISPLAY - -
3 Display Sub-Frame difference “ SY DISPLAY - Press to return to H:M:S:F display
4 Auto Offset Calculate & Store “ SY DISPLAY and Time code offset only
5 Display Generator Start Time & Enter
Data GEN SY DISPLAY or -
6 Column by column Generator or
Offset time Setting GEN
or
OFFSET
Hold and then
press DISPLAY
or A period will start blinking in the Hours column, use
or to enter hours. Press DISPLAY to move the
period to next column. After setting last column,
pressing DISPLAY will exit column setting mode
7 Display MEMO 1 & Enter data MEMO 1 DISPLAY or By pushing MEMO 1, point can be set on the fly
8 Display MEMO 2 & Enter data MEMO 2 DISPLAY or By pushing MEMO 2, point can be set on the fly
9 Display OFFSET & Enter data OFFSET DISPLAY or ABS time Offset entry in Frames only.
10 Display OFFSET & Enter Data “ SY DISPLAY or SMPTE T/C Offset entry in Frames, or when DISPLAY
is pressed again, in Sub-Frames.
11 Display PITCH & Enter data PITCH DISPLAY or VARI or -
12 Display Tape Time Code TC SY Hold DISPLAY + - -
13 Display User Bits on tape SY Hold + DISPLAY - TC LED will flash
14 Display Incoming Time Code “ SY Hold + Display - TC LED will flash. Press DISPLAY to exit.
15 Pull Up / Down mode setting “ SY Hold and press Fs or Press DISPLAY to exit
16 Display Pull Up / Down Status Any SY Press Fs button - Display will exit automatically