Texas Instruments bq24013 - Manual (Page 17)

Bill of Materials
3-5 Schematic, Physical Layouts, and Bill of Materials
3.3 Bill of Materials
Table 3–1 lists materials required for the EVM.
Table 3–1. Bill of Materials
Item# bq24013
Ref
Des Description Size MFR Part Number
1 0 C1 Capacitor, ceramic, X5R, 1 µ F, 10 V 805 Panasonic ECJ-2YB1A105K
2 1 C2 Capacitor, ceramic, X5R, 1 µ F, 10 V 805 Panasonic ECJ-2YB1A105K
3 1 C3 Capacitor, ceramic, X7R, 0.47
µ
F, 16 V 805 Panasonic ECJ-2YB1C474K
4 1 D1 Diode, LED, red, 1.8 V, 20 mA, 20 mcd 603 Lite-On 160-1181-1-ND
5 1 D2 Diode, LED, green, 2.1 V, 20 mA, 6 mcd 603 Lite-On 160-1183-1-ND
6 1 J1 Terminal block, 2 pin, 6 A, 3,5 mm 0.27
×
0.25 OST ED1514
7 2 J2, J3 Terminal block, 4 pin, 6 A, 3,5 mm 0.55 × 0.25 OST ED1516
8 2 J4, J5 Header, 3 pin, 100 mil spacing, (36-pin
strip) 0.100 × 3 Sullins PTC36SAAN
9 2 R1, R2 Resistor, chip, 1.5 k
Ω
, 1/16 W, 1% 603 Std Std
10 0 R3 Resistor, chip, 1 M
Ω
, 1/16 W, 1% 602 Std Std
11 2 R5, R6 Resistor, chip, 10 k Ω , 1/16 W, 1% 603 Std Std
12 1 R4 Resistor, chip, 1.3 k Ω , 1/16 W, 1% 603 Std Std
13 1 U1 IC, single Li-Ion/Li-Polymer, charge
manager MLP10 TI bq24013DRC
14 2 — Shunt, 100-mil, black 0.100 3M 929950-00
15 1 — PCB, bq24010/2, 1.6 in × 1.3 in × 0.031 in Any SLUP185
Notes: 1) These assemblies are ESD sensitive; ESD precautions must be observed.
2) These assemblies must be clean and free from flux and all contaminants. Use of no-clean flux is not acceptable.
3) These assemblies must comply with workmanship standards IPC-A-610 Class 2.
4) Reference designators marked with an asterisk (**) cannot be replaced by substitutes. All other components can
be replaced with equivalent manufacturer components.
3.4 Reference
1) bq2401x data sheet (SLUS530)