English – Vitek VT-2342 User Manual

Page 6

ENGLISH

Selecting Speed
After switching the appliance on it starts
operating at low speed (default speed). You
can change the speed by pressing button

“SPEED” (5) on control panel (1) or on re-
mote control (22). Every pressing switches
to operating mode according to the next
sequence: noiseless operation, low speed,
middle speed, high speed, automatic
mode.
Selected operating mode is indicated by
speed indicator (10) located on display
(7). If you have chosen noiseless operating
mode first tree points of indicator are light-
ed, in case you have chosen low speed first
five points of indicator are lighted, in case
you have chosen middle speed first seven
points of indicator are lighted. In case you
have chosen high speed all points of indi-
cator are lighted.

Setting Timer
Press button «TIMER» (4) on control panel
(1) or button (24) on remote control (22)
to change the time of appliance operation.
Every pressing increases time of appliance
operation for one hour. Selected time of
operation is indicated by timer (14). After
the set time of operating is over, the appli-
ance will be switched off.

Switching On Ionization Mode
Press button “ION” (3) on control panel (1)
of button (26) on remote control (22) to
switch on ionization mode. Icon (8) will be
lighted on display (7).

Switching On UV-Lamp
Press button “UV” (2) on control panel (1)
or button (26) on remote control (22) to
switch on UV-lamp, icon (9) will be lighted
on display (7).

Filters’ Block Replacement Indicator
While using air purifier the points of filters’
block replacement indicator (11) are light-
ed one by one. When all points of indica-

tor (11) are lighted it is required to replace
filters’ block. When using purifier in rooms
with very contaminated air you can replace
filters before all points of indicator (11)
are lighted. After installation of new filters’
block press and hold button “SPEED” for 3
seconds, you will hear sound signal and all
points of indicator (11) will be deemed. This
means the appliance is ready for the next
cycle of filters’ block usage.

Dust and Smell Indicators
The more air is contaminated the more
number of points of the adequate indica-
tors (12, 13) are lighted.

APPLIANCE MAINTENANCE
Wipe the housing of the appliance by dry
cloth. It is forbidden to immerse the appli-
ance into water.
Clean air inlets by dry soft brush. Also you
can use a vacuum cleaner with the ade-
quate nozzle.

Cleaning Appliance
Make sure the appliance is disconnected
from the wall outlet before cleaning.
Take lower corners of the air inlets lid and
pull it towards yourself (Picture 2). Remove
the lid (Picture 3). Take filters’ block out by
pulling the strips (Picture 4). Detach pre-
liminary cleaning filter (Picture 5). After
200-300 hours of operation the filter should
be washed and cleaned by vacuum cleaner.
After cleaning install preliminary filter into
its position. Clean the lid with air inlets by
vacuum cleaner and wipe it by damp cloth.

Replacing Filters’ Block
In order to provide effective operation of
the appliance it is recommended to replace
filters’ block every six months of continu-
ous operation.
Make sure the appliance is disconnected
from the wall outlet before replacing filters’
block.
Take lower corners of the air inlets lid and

2342.indd 6

02.08.2007 12:06:37