Toshiba SX-2801 - Manual (Page 17)

INSTALLATION
17
USING A HEADSET
You can use an optional headset (part#: RC 008260) that has a 3/32-
inch(2.5mm) plug.
To connect the headset, open the
rubber cover on the left side of the
handset, then insert the headset's plug
into the jack.
With a headset connected, you can
make or answer calls as usual using
the keys on the handset.
When you finish using the headset,
disconnect it from the handset and
close the rubber cover to protect the
jack.
NOTES:
• The handset's earspeaker and microphone are turned off with a headset
connected.
• Pressing the ( ▲,▼) button of the handset also controls the
connected headset's volume.
• If you place the handset on the base unit while the headset is connected, be
sure the handset is placed properly.
VOL/RING
Preparation
TA LK CID
TA LK CID
SX-2801.qxd 3/15/1 6:02 PM Page 17