Toshiba W-707 - Manual (Page 42)

42
Setting Control Codes
1
Press TV to set the remote control operating your TV.
2 While holding down PROG , enter the
two digits of your TV’s brand code
(listed right) using
number buttons .
3 Release PROG .
4 Point the remote control at your TV and use each button listed
below to make sure that your TV is operated correctly.
TV POWER To turn the TV on or off.
CH/TRK To select TV channels in the upper or lower
direction.
TV VOL To adjust the sound level.
INPUT SELECT To select an external source such as a VCR.
Number buttons To select TV channels. When selecting channels
1 to 9, first enter 0 and then the desired number.
100 To substitute for 100 channel key.
DISPLAY To turn on or off TV’s screen display.
ENTER To use for the TV’s ENTER key.
Important
Some TVs may not respond to all the operations above, or
may not be operated at all with this remote control. In this
case, operate your TV with its own remote control.
Notes
• For some brands, several control codes (brand codes) are allocated. Try
each of them until the buttons work on your TV.
• If you replace the remote control’s batteries, set the brand code again.
Multi Brand Remote Control
The remote control can be compatible with various brands of TV by setting their control codes. The
TOSHIBA code has initially been set to control TOSHIBA TVs.
ADDITIONAL INFORMATION
Hold down. Example
0 2
PROG
100
TV POWER
DISPLAY
INPUT
SELECT
TV VOL
Number
buttons
1
TV/VCR
1 2 3
4 5 6
7 8 9
0
a
+
–
8
9
J
PROG
+
–
RE V FW D
( ) -
L
ENTER
CH/TRK
2, 3