Toshiba W-707 - Manual (Page 24)

24
Index Search Function
The VCR can find a point where a registered index signal is on a
tape and play back for about 5 seconds. You can easily locate
the desired program by inputting the index signal.
Registering index signals
Each time a recording starts, an index signal is automatically registered.
To register it somewhere else, press
INDEX (+) during recording.
Note
A certain interval is required between the index signals: more than 1 minute in
the SP tape speed and more than 3 minutes in the SLP tape speed.
Index search
1
Load a cassette with the index signals registered.
2
Press INDEX (–) or (+) in the stop or playback mode.
–: To search in the reverse direction.
+: To search in the forward direction.
The VCR fast-forwards or rewinds the
tape. When an index signal is found, the
VCR plays back the tape for about 5
seconds, and then resumes fast-
forwarding or rewinding. This is repeated
each time at an index signal.
3 Press PLAY when the desired program is found.
Normal playback starts.
Notes
• At the very beginning of the tape, the index search may not work properly.
• If you registered the index signals on a tape recorded on another VCR, the
recording may be blurred at the index point and the index search may not
work properly.
5
Press PROG to exit.
6 Press REMAIN/COUNTER .
The remaining time (“RT - : - -”) appears in the VCR display.
Notes
• The displayed remaining time is an approximation.
• The remaining time is calculated according to the tape speed (SP or SLP)
and the cassette type.
2 1 1 2
Playback
for 5 sec. Playback
for 5 sec. Playback
for 5 sec. Playback
for 5 sec.
Index search
0 0 0 0 0
H M S
I NDEX MARK
TV/VCR
1 2 3
4 5 6
7 8 9
0
a
+
–
8
9
J
PROG
+
–
RE V FW D
( ) -
L
2
3
Useful Functions In Tape Operation (continued)