Toshiba SD-250E-S-TE - Manual (Page 4)

- 4 - EN
SAFETY PRECAUTIONS
Notes on copyrights:
It is forbidden by law to copy, broadcast, show, broadcast via cable, play in public, or rent copyright material without
permission.
This product is equipped with copy protection measures developed by Macrovision. Copy protection signals are recorded
on some discs. When recording these discs on a VCR, picture noise will appear during playback.
This product incorporates copyright protection technology that is protected by certain U.S. patent claims and other
intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection
technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only
unless otherwise authorized by Macrovision Corporation . Reverse engineering or disassembly is prohibited.
The following information applies only to the model for U.K.
WIRING : This unit is supplied with a BSI 1363 approved 13 amp mains plug, fused at 5 amp. When replacing the fuse
always use a 5 amp BS 1362, BSI or ASTA approved type. Never use this plug with the fuse cover omitted. To obtain a
replacement fuse cover contact your dealer. If the type of plug supplied is not suitable for the mains sockets in your home,
then the plug should be removed and a suitable type fitted.Please refer to the wiring instructions below:
WARNING: A mains plug removed from the mains lead of this DVD player must be destroyed. A mains plug with bared wires
is hazardous if inserted in a mains socket.
Do not connect either wire to the earth pin, marked with the letter E or with the earth symbol or coloured green or green
and yellow.
If any any other plug is fitted, use a 5 amp fuse, either in the plug, or at the distribution board.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following codes:
- BLUE: NEUTRAL , BROWN: LIVE - As the colours of the wires in the mains lead of this DVD player may not correspond
with the coloured marking identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must
be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must
be connected to the terminal which is marked with the letter L or coloured red.