Topcom Skyr@cer WBR 7121 - Manual (Page 14)

8
Setup the Broadband Router
2 MAC Address: Some Cable Internet Providers will keep the MAC address of
your computer in their server. In this case you should clone the Mac address of
your computer.
JClick Clone Mac Address to copy your computers Mac address into the
router.
•
Use the following IP address:
1
IP address: Please enter the fixed IP address.
2 Subnet Mask: Enter the Subnet mask.
3 Default Gateway: Enter the Gateway IP address.
•
L2TP Settings:
1
User ID: Enter the L2TP username.
2
Password: Enter the L2TP password.
3
L2TP Gateway: Enter the Gateway.
4 Connection ID: Enter the Connection ID when necessary.
5 MTU: Enter the MTU size (If the size is not specified by your internet provider,
please leave the default value at 1492)
6 Connection Type:
•
Continuous: The PPP-connection will always be active
•
Connect on Demand: The PPP-connection will establish when a
computer is accessing the Internet. The PPP connection will disconnect
when there is no more Internet traffic during the Idle Time (minutes),
entered in the field below.
•
Manual: The PPP connection is established / disconnected manually by
clicking Connect / Disconnect.
JClick Ok to proceed. (Go to “ Finishing the Broadband Connection Type Setup Wizard”
on page 8)
o
Telstra Big Pond: not for Europe
Finishing the Broadband Connection Type Setup Wizard
Now the quick setup wizard for your Broadband Type is finished.
J Click Apply to finish.