Triax STR 333 - Manual (Page 12)

2.2 Easy Installation
Ƈ C/KU Switch:
You can select C/KU band by selection of switch type.
(None, DiSEqC Switch)
Ƈ Position (DiSeqC 1.2)
After selecting a satellite, please select position number.
To change value, press the OK button.
The position list will be displayed.
Ƈ LNB Freq.
Select the proper LNB frequency referring to your LNB using the OK and
the UP/DOWN buttons.
Ƈ C-LNB Freq.
When selecting the C/KU Switch is selected as “None”, the C-LNB Freq
will be dimmed automatically.
Press the
OK button, and then the C-LNB Freq. list will be displayed.
You can also input the freq. you want. After inputting freq.
Using the
NUMERIC buttons, press the OK button.
(None, DiSEqC Switch)
Ƈ LNB Power
Select the LNB Power On or OFF.
Ƈ 22KHz
Depending on the user’s antenna switch box or LNB. You can supply
either 22KHz by setting “
ON ” or not by setting “ OFF ”.
Ƈ Tone Burst
Depending on the user’s antenna switch box. (“off”, “SAT A” or “SAT B”)
Ƈ DiSEqC - DiSEqC
You can select and use appropriate port for your DiSEqC switch box.
Press the
OK button to select DiSEqC List. (None, DiSEqC A, DiSEqC B,
DiSEqC C, DiSEqC D, Motor, USALS)
Ƈ DiSEqC - DiSEqC 1.2 and USALS
Press the BLUE button to set Drive(Fine Drive or Normal Drive) to run
the motor.
•
Fine Drive/Normal Drive
To move the motor, press the LEFT/RIGHT button.
• Go to zero
To move the zero position, press the OK button.
• Store to location
To store the current position, press the OK button.
• East Limit
To set the east limit by current position, press the OK button.
• West Limit
To set the west limit by current position, press the OK button.
• Clear Limit
To clear the stored limit value, press the OK button.
12