Trust Computer Products 1290Z - Manual (Page 13)

TRUST 1290Z POWERC@M OPTICAL ZOOM
Symbol Status Function
Automatic The camera automatically uses the flash when so
required.
On The flash will be used for all photographs. This is
ideal when fill-in flash is needed (against the light).
N.B.: the flash is turned off in burst mode.
Off The flash is not used.
Red-eye
reduction The flash will be automatically used when there is
insufficient light; an advance flash will be used to
reduce the red-eye effect.
Table 6: summary of flash settings
9 Recording video clips ( )
You can use this function to record video clips of a maximum duration of 30 seconds.
1. Turn the selector dial to video mode ( )
2. Press the shutter release button to begin recording. The camera will then
make a recording until 30 seconds have passed or the shutter release button
is pressed again.
N.B.: the digital zoom cannot be used.
N.B.: you cannot zoom in or out during the recording.
10 Viewing pictures / videos
10.1 Display on the camera ( )
To view photos turn the selector dial to Playback mode and switch on the camera.
The last photo you took will be displayed.
The default Playback method is to display individual photos on the full screen. Press
the “Å” button or “Æ” button to browse through the photos stored in the memory.
9
U K
N.B.: you will need to wait about 5 seconds before the photo is shown
on the LCD display, allowing you to browse to the next photo