Controlling your tv with the supplied remote, Setting tv control codes, Important – Toshiba SD-V596SU User Manual
Page 38
The remote control can be compatible with various
brands of TV/Cable box/DSS satellite receiver by setting
their control codes. The TOSHIBA code has initially
been set to control TOSHIBA TVs.
Setting TV Control Codes
1. Press TV to set the remote control operating
your TV.
2. While holding down PROGRAM button, enter
the two digits of your TV’s brand code (listed on
page
39
) using number buttons.
3. Release PROGRAM.
By pressing
You can
POWER
Turn the TV on or off.
CH/TRK +/–
To select TV channels in the upper
or lower direction.
VOL +/–
Adjust the volume of the TV.
Number buttons
To select TV channels.
When selecting channels 1 to 9,
first enter 0 and then the desired
number.
100
To substitute for 100 channel key.
DISPLAY
To turn on or off TV’s screen
display.
INPUT SELECT
Switch the TV’s input source
between the TV and other input
sources.
ENTER
To use for the TV’s ENTER key.
Notes:
For some brands, several control codes (brand
codes) are allocated. Try each of them until the but-
tons work on your TV.
If you replace the remote control’s batteries, set the
brand code again.
DISPLAY
INPUT SELECT
TV
POWER
PROGRAM
Number
buttons
100
CH/TRK, VOL
ENTER
Important
Some TV’s may not respond to all the operations
above, or may not be operated at all with this
remote control. In this case, operate your TV with
its own remote control.
38
Controlling Your TV with the Supplied Remote