Thermador T36IB70NSP - Manual (Page 26)

26
q Measure the distance X between the adjusting rail
and the overhead furniture/fixtures.
q Loosen the 2 nuts and remove the adjusting rail.
q Mark this amount X on the rear of the furniture door.
q Determine and mark the centre of the furniture door.
q Put on the adjusting rail and align along the marks.
Mark the drill holes.
q Drill the holes.
q Screw on the adjusting rail tightly.
i Note
- Attach the adjusting rail to the furniture door with at
least 10 screws. One screw should be inserted
under each double threaded bolt.
- The adjusting rail features a variety of holes for the
many different design options of furniture doors.
Always screw into the best loadĆbearing material
of the furniture door.
- Never screw into fillers, decorative strips or similar.
21. Attaching and aligning
the furniture door
(refrigerator compartment)
i The double threaded bolts are responsible for
adjusting the height of the furniture front.
q Hang the furniture door on the double threaded
bolt.
q Align the furniture door with the double threaded
bolts (Torx screwdriver).