4 - basic operations, 1 power-up procedure, 2 inserting discs – Tascam CD-D4000 MKII User Manual
Page 7: 3 power down, 4 modes
TASCAM CD-D4000 MKII
7
4 - Basic operations
4.1 Power-up procedure
When the unit is first powered up using the power
switch
1
, it performs a self-check operation, and the
screen shows the following:
followed by
:
If the self-check is passed, the display will show the
first menu screen, otherwise an error message will be
displayed.
4.2 Inserting discs
Press the eject button of the
MASTER
or the
SLAVE
drive to open the disc tray.
Place discs label side uppermost in the disc tray.
To insert the discs into the
MASTER
drive, you may
find it useful to place the front of the disc into the
disc tray first, and then seat the back of the disc into
the tray.
If a disc is placed into a tray upside-down or off-cen-
ter, an error message will appear on the display.
You can close the disc trays by pressing the eject but-
ton on the drive (though many operations will close
the disc trays automatically).
4.3 Power down
Before powering down the unit, eject discs from both
drives (the eject mechanism requires power to work,
and so you will not be able to eject the discs once
power is turned off).
NOTE
Do not turn off the CD-D4000 MKII while writing to
the slave disc (i.e. part of the way through a disc
copy operation. If you do, the disc will be corrupt,
and unusable.
4.4 Modes
The different modes available are:
• Copy
• Test write
• Compare CD-ROM
• Play audio
• Write speed selection
These are accessed by pressing the
MODE
key.
Details of these modes are given below.
When the required mode is shown on the lower line
of the display, press the
ENTER
key to enter the
mode.
When the word
Exit
appears on the display, the
ENTER
key will halt the current operation.
T A S C A M
C D - D 4 0 0 0
M K 2
T A S C A M
I n i t i a l i z i n g