Tascam CD-D4000 MKII - Manual (Page 10)

10
TASCAM CD-D4000 MKII
7 - Compare CD-ROM
This mode is used for comparing a CD-ROM which
has just been duplicated using the copy mode. It can-
not be used for audio CDs.
1
Press the MODE key until the display shows the
following:
2
Press ENTER :
3
Make sure that the original disc is in the
MASTER drive disc tray, and the copy disc is in
the SLAVE drive disc tray.
4
Press ENTER :
As the comparison process proceeds, the per-
centage of the process which has been com-
pleted is shown on the display.
Note that the comparison process is carried out
quicker than recording or testing. The time
taken for comparison is independent of any
speed settings made (these only affect the
recording speed).
5
When the comparison has finished successfully,
the display shows:
The compare operation can be stopped at any
time by pressing and holding down the
MODE
key and pressing the ENTER key. An error
message will be displayed and you should use
the
MODE key to return to the mode selection.
If there has been an error in the comparison (i.e.
the two CDs do not match) or if they do not
match in any other way (the wrong pair of discs
has been loaded), the compare operation will
stop at the point at which the mismatch was
detected, and the display will show:
7.1 Play audio track
Since it is impossible to make a bit-by-bit compari-
son of audio CDs, this function is provided for you to
“audition” a CD copy, using a pair of headphones
connected to the
MASTER or SLAVE drive head-
phone jack.
Any standard headphones with a 3.5 mm stereo jack
may be used. The volume is adjusted using the
drive’s volume control (turn to the right to increase
the volume, and to the left to decrease the volume.
1
Press the MODE key until the display shows the
following:
2
Press ENTER:
3
Use the MODE key to toggle between
Master and Slave , with a third option
being to exit ( Exit ) the play audio mode.
Press the ENTER key to confirm the selection:
After the ENTER key has been pressed, a
Please wait ... message is
briefly shown and track 1 will start playing.
Pressing ENTER again will jump to the next
track and start playback. If the last track is
reached in this mode, and the
ENTER key is
pressed, playback will start at the first track.
4
If the MODE key is pressed from the screen
above, the display changes:
Pressing the ENTER key will start playing the
track before the current track. If the first track is
currently being played, and the
ENTER key is
pressed, the last track will start playing.
5
Pressing the MODE key from the display shown
above will change the display again:
M o d e s e l e c t
3 C o m p a r e C D - R O M
C o m p a r e C D - R O M
R e a d y ?
C o m p a r i n g ø
4 %
C o m p a r e f i n i s h e d
C o m p l e t e
C o m p a r e f i n i s h e d
F a i l
M o d e s e l e c t
4 P l a y a u d i o
D r i v e s e l e c t
M a s t e r
T r a c k 0 1 P l a y
1 N e x t t r a c k
T r a c k 0 1 P l a y
2 P r e v i o u s t r a c k
T r a c k 0 1 P l a y
3 E x i t