THALES DATACRYPTOR - Manual (Page 123)

Datacryptor Ethernet User Manual Appendix I: Log and SNMP Trap Numbers
1270A450-005 - June 2008 Page 123
Audit Errors
Log Type Code Trap
No. Severity Message Information
Audit 1 701 Informational Session started User has successfully
logged into unit
Audit 2 702 Informational Session stopped User has logged off
Audit 3 703 Informational Session stopped - lost
contact with host
Session has been
terminated, user unable to
communicate with unit
Audit 4 704 Informational Viewed logs User is viewing the logs
Audit 5 705 Informational General configuration
updated
User has altered either
unit Time/Date or
interface settings
Audit 6 706 Informational Security configuration
updated
User has altered either
KEK lifetime, DEK Lifetime
Change DEK with KEK
option setting, Movement
or Temp alarm status,
Erase Button Key
requirement
Audit 7 707 Informational Serial port configuration
updated User has altered one of
the control port
parameters This could be
either Baud Rate, Data
Bits, Parity or Stop Bit
values
Audit 8 708 Informational IP management
configuration updated
User has altered the IP
address
Audit 9 709 Informational Comms configuration
updated
Audit 10 710 Informational T1 configuration updated
Audit 11 711 Informational E1 configuration updated
Audit 12 712 Informational Line test configuration
updated
Audit 13 713 Informational Date/time before update Unit time at time of
time/date change, with
respect to new time
Audit 14 714 Informational Date/time after update Unit time at time of
time/date change, with
respect to old time
Audit 15 715 Informational Reboot unit Unit Soft Rebooted
Audit 16 716 Informational Initiate diagnostic test
Audit 17 717 Informational Standby mode configured
Audit 18 718 Informational Plain mode configured