Toshiba 36AX61 - Manual (Page 17)

17
Ref
er
ence
W
elcome to Toshiba
Connecting
y
our T
V
Using the
Remote Contr
ol
Setting up
y
our T
V
Using the T
V’s
F
eatur
es
Appendix
Index
Verifying the device code (990)
Use this feature to verify the codes for your other devices. The
number of blinks after pressing the 1, 2, 3, and 4 buttons is the
4-digit code set up for that mode.
For example, to verify the VCR device code:
1. Press MODE to select the VCR mode.
2. While holding down RECALL, press 9, 9, 0 in sequence.
3. Press 1
➝ 0 blinks.
4. Press 2 ➝ 3 blinks.
5. Press 3 ➝ 8 blinks.
6. Press 4 ➝ 5 blinks.
This verifies that the device code of the VCR is “0385.”
Using the Volume Lock feature (993)
For the TV, CABLE/SAT, VCR, and DVD modes, the volume
controls (VOL
yz and MUTE) can be programmed (locked) to the
selected device mode. This feature does not apply to the AUDIO1/2
modes.
For example, to lock the volume controls to the CABLE/SAT mode:
1. Press MODE to select the CABLE/SAT mode.
2. While holding down RECALL, press 9, 9, 3 in sequence.
3. Press VOL
y. The Mode indicator will blink two times (locked).
The following table describes the Volume Lock implementation.
Volume
TV CBL/SAT VCR DVD AUD1 AUD2
Locked to:
TV (default) TV
TV TV TV AUD1 AUD2
CBL/SAT CBL/SAT CBL/SAT CBL/SAT CBL/SAT AUD1 AUD2
VCR VCR VCR VCR VCR AUD1 AUD2
DVD DVD DVD DVD DVD AUD1 AUD2
AUD1 AUD1 AUD1 AUD1 AUD1 AUD1 AUD1
AUD2 AUD2 AUD2 AUD2 AUD2 AUD2 AUD2
To reset the volume controls to the original device code:
1. While holding down RECALL, press 9, 9, 3 in sequence.
2. Press VOL
z. The mode indicator will blink four times
(unlocked).
Operational feature Reset (980)
This feature clears all setup features not related to “Device code set
up” and resets the Volume Lock to “TV.”
To reset the features:
While holding down RECALL, press 9, 8, 0 in sequence.
The mode indicator will blink two times, and then pause and
blink two more times.
CHANNEL
NUMBERS
MODE
RECALL
VOL y z