Tascam CD-RW402 - Manual (Page 18)

3 – Features and controls—Rear panel features
18
TASCAM CD-RW402 Owner’s Manual
Rear panel features
Digital connections These connections all han-
dle digital audio I/O.
k COAXIAL INPUT and OUTPUT
(DRIVE 2)
These RCA connectors accept and
transmit digital audio data to and from drive 2
respectively in SPDIF format.
The IN connector accepts AES3-1992 (TYPE I) as
well as SPDIF (TYPE II) format data. The unit auto-
matically detects the data type. Input may be from
32 kHz to 48 kHz, and output is always at 44.1 kHz.
l OPTICAL INPUT and OUTPUT
(DRIVE 2)
These TOSLINK-type optical connec-
tors accept and transmit digital audio data to and
from drive 2 respectively in SPDIF format.
The IN connector accepts AES3-1992 (TYPE I) as
well as SPDIF (TYPE II) format data. The unit auto-
matically detects the data type. Input may be from
32 kHz to 48 kHz, and output is always at 44.1 kHz.
m COAXIAL OUTPUT (DRIVE 1) This
RCA connector outputs digital audio data from drive
1 in SPDIF format.
n OPTICAL OUTPUT (DRIVE 1) This
TOSLINK-type optical connector outputs digital
audio data from drive 1 in SPDIF format.
Analog connections These connections all han-
dle analog audio I/O.
o UNBALANCED INPUT (2) These unbal-
anced RCA connectors allow the input of –10 dBV
nominal level signals to drive 2 (red=right).
p UNBALANCED OUTPUT (2) These
unbalanced RCA connectors output the signal from
drive 2 at –10 dBV nominal levels (red=right).
q UNBALANCED COMMON OUT These
connectors are used in the same way as the
COMMON setting for the headphone monitoring D .
Drive 1 takes priority if both drives are playing, oth-
erwise the currently-playing drive takes priority
(red=right).
r UNBALANCED OUTPUT (1) These
unbalanced RCA connectors output the signal from
drive 2 at –10 dBV nominal levels (red=right).
s BALANCED INPUT [L, R] (2) These bal-
anced XLR-type female connectors accept analog
signals at +4 dBu nominal levels to drive 2.
t BALANCED OUTPUT [L, R] (2) These
balanced XLR-type male connectors output the ana-
log outputs from drive 2 at +4 dBu nominal levels.
u BALANCED OUTPUT [L, R] (1) These
balanced XLR-type male connectors output the ana-
log outputs from drive 1at +4 dBu nominal levels.
NOTE
All XLR-type connectors are wired with 1=ground,
2=hot, and 3=cold.
Other connections These are control and power
connections.
v CONTROL I/O This connector allows for
remote control and fader stop/start control of the
k l m n o p q r s t u
v w x