Toshiba GD-1250 - Manual (Page 114)

7 TROUBLESHOOTING AND SPECIFICATIONS
112 Troubleshooting
Troubleshooting
„ Error codes
Below is a list of error codes that you might see in the lists or reports.
If you see an error code not listed here, retry the communication. If this error still occurs, contact your service
technician or service representative.
„ Error messages
Below is a list of error messages that might appear on the touch panel. When any message in the list appears on the touch
panel, press [FUNCTION CLEAR] on the control panel to clear it, and then take action suggested in the “Remedy” column.
Never attempt to repair, disassemble or modify the equipment by yourself.
You could cause a fire or get an electric shock. Always contact your service representative for maintenance or repair of the
internal parts of the equipment.
For error messages not listed above and their solutions, refer to the Troubleshooting Guide.
Error Code Description Remedy
0012 Original jam Clear the jammed original.
0013 Door open Firmly close the open door.
0020 Power interruption Check the power interruption report.
0030 Reset Transmission is cancelled.
(The transmission is terminated by the jammed printing paper during the
direct transmission.)
0033 Polling Error Check polling options setup (Security code, etc.), and check if the polling
document exists.
0042 Memory full Make sure that there is sufficient memory before making the call again.
0050 Line busy Retry communications.
0053 Security mismatch in relay or mail
box transmission Confirm the remote party’s security code, system password, and your
setup.
00B0 - 00E8 Communication Error Retry communications.
Message Cause Remedy
Memory overflow Memory overflowed when scanning documents to
the memory. Either wait for memory to be cleared, or check
the jobs and delete reserved jobs to clear
memory.
Communication error Communication error occurred during direct TX. Retry communications.
Job reservation full The number of reserved jobs exceeded 100. Either wait for job reservations to be completed,
or check the jobs and delete reserved jobs.
Job memory full The total number of destinations for reserved jobs
exceeded 1000. Either wait for job reservations to be completed,
or check the jobs and delete reserved jobs.
Sorry not possible On-hook or direct TX was attempted during
communications. Wait for communications to end and retry
communications.
Not allowed now Further polling transmission reservation was
attempted even though polling transmission was
already reserved. Either wait for polling transmission jobs to be
completed, or check the jobs and delete reserved
jobs.
Too Many Tel # Digits 128 digits or more were registered for a chain dial
communication. Confirm the number of digits dialed and register
the numbers again.