Telstrat 7300A - Manual (Page 23)

44 45
5. Use .LWW^ or to display the handset number you wish to de-register, then press 8PY` .
6. Deregister? will be displayed, press 8PY` again to confirm.
Restore default settings
You can reset your Telstra 7300/7300a handset to its default (original) settings.
1. Press 8PY` to open the main menu.
2. Press .LWW^ or until the display shows Setup h/set and press 8PY` .
3. Press .LWW^ or until Reset is displayed and press 8PY` .
4. Reset? is displayed. Press 8PY` . Saved is displayed.
Language
You can change the default language used by your Telstra 7300/7300a from English to German or
Turkish.
1. Press 8PY` to open the main menu.
2. Press .LWW^ or until the display shows Setup h/set and press 8PY` .
3. Press .LWW^ or until Language is displayed and press 8PY` .
4. Scroll .LWW^ or to choose the default language and press 8PY` to confirm.
5. Press and hold 8`_P to return to standby.
Handset settings Handset settings
Registering handsets
If you have purchased a Telstra 7300/7300a multi handset pack, the handsets in these packs are
already pre-registered to the main base.
If however you de-register a handset and need to re-register it back to a Telstra 7300/7300a base at
any stage:
1. Press 8PY` and enter using the keypad.
2. Registration is displayed, press 8PY` .
3. Register is displayed, press 8PY` and Enter PIN will be displayed.
4. Enter the base PIN (original setting 0000) and press 8PY` .
5. The handset will display Searching, press and hold the ;LRP button on the base until you receive a
confirmation tone.
6. The handset will temporarily display Registered then will display Handset and will be
automatically assigned the next handset number.
Your Telstra 7300/7300a is not GAP compatible and registration is therefore generally limited to other Telstra 7300/7300a
handsets. The Registration and De-registration menu’s are therefore “hidden” and can only be accessed after entering the
code
De-registering a handset
You can de-register any handset from a base using any of the handsets that are registered to it.
1. Press 8PY` and enter using the keypad.
2. Registration is displayed, press 8PY` .
3. Press .LWW^ or until Deregister is displayed, press 8PY` and Enter PIN will be displayed.
4. Enter the base PIN (original setting 0000) and press 8PY` .