Toshiba W-627 - Manual (Page 29)

Setting TV Control Codes
1 Press TV to set the remote control operating your TV.
2
3
Release PROG.
4 Point the remote control at your TV and use each button
listed below to make sure that your TV is operated correctly.
POWER To turn the TV on or off.
CH/TRK To select TV channels in the upper or lower
direction.
TV VOL To adjust the sound level.
I.SELECT To select an external source such as a VCR.
Number buttons To select TV channels. When selecting channels
1 to 9, first enter 0 and then the desired number.
100 To substitute for 100 channel key.
DISPLAY To turn on or off TV’s screen display.
ENTER To use for the TV’s ENTER key.
TV VCR
PROG. ENTER
TV/ VCR
POWER
CH/TRK
TV VOL
I.SELECT
REMAIN/ COUNTER DISPLAY COUNT RESET
SP/ SLP REC TIMER
SLOW PLAY/x2 PAUSE/STILL
REW F F
CURSOR
STOP
CANCEL
A.SELECT
EJECT CM SKIP
1 2 3
4 5 6
7 8 9
0 100
1
POWER
CH/TRK
TV VOL
100
Number
buttons
DISPLAY
I.SELECT
ENTER
2, 3
While holding down PROG. enter the two digits of your TV’s
brand code (listed on page 30 ) using number buttons.
29
Important
Some TV’s may not respond to all the operations above, or
may not be operated at all with this remote control. In this
case, operate your TV with its own remote control.
Notes
• For some brands, several control codes (brand codes) are allocated. Try
each of them until the buttons work on your TV.
• If you replace the remote control’s batteries, set the brand code again.
ADDITIONAL
INFORMA
TION
ADDITIONAL INFORMATION
Multi Brand Remote Control
The remote control can be compatible with various brands of TV by setting their control codes. The
TOSHIBA code has initially been set to control TOSHIBA TVs.
W-627 Eng(29-36) 2/28/02, 3:30 PM 29