Toshiba Tosvert Inverter E6580772 - Manual (Page 13)

E6580772
12
3.1.3 Communication parameters
„ F10M communication parameters
Parameter name Title Setting value Details
Inverter number f802 0 to 255 Sets inverter station address. (Note 1)
When using a message transmission, set the address of the
master station to 0 and address of the inverter station to 1 or
over.
Data type
selection f830 0 , 1 Selects type of transmitting and receiving data.
0: VFA7 mode
1
:μs 250 mode
Input reference
setting 1 f831
Input reference
setting 2 f832
Input reference
setting 3 f833
Input reference
setting 4 f834
Input reference
setting 5 f835
Input reference
setting 6 f836
0 to 16 Sets scan transmission data to be received.
0 : Without setting
1 : Command
2 : Speed reference value
3 : Auxiliary speed reference value
4 : Torque limit value
5 : Positive torque limit value
6 : Negative torque limit value
7 : Torque command value
8 : Synchronized torque bias
9 : Tension torque bias
10 : Load sharing gain
11 : Drooping gain
12 : Speed loop proportional gain
13 : Speed loop accumulative gain
14 : Terminal output data
15 : Inertia moment ratio
16 : Expansion command
Monitor output
setting 1 f841
Monitor output
setting 2 f842
Monitor output
setting 3 f843
Monitor output
setting 4 f844
Monitor output
setting 5 f845
Monitor output
setting 6 f846
0 to 16 Sets scan transmission data to be sent.
0 : Without setting
1 : Status
2 : Operation frequency
3 : Speed feedback value (real time)
4 : Speed feedback value (1-second filter)
5 : Internal torque reference value
6 : Output amperage
7 : Exciting amperage
8 : Torque amperage
9 : Overload accumulative value
10 : Deleted torque of acceleration/deceleration torque
11 : Motor counter data
12 : Error code
13 : Input terminal data
14 : VI input
15 : RR input
16 : RX input