Remote control unit – Teac A-R610 User Manual
Page 7
7
ENGLISH
Remote Sensor
When operating the remote control unit, point it towards the
REMOTE SENSOR.
POWER
Press this switch to turn the unit standby or off.
STANDBY/ON
When the power switch of the main unit is depressed, use
this button to turn the unit on or standby.
The standby indicator lights when the unit is in the standby
mode. When the unit is turned on, it goes off.
INPUT SELECTOR
Use this knob (or buttons of the remote control unit) to select
a source.
One of the indicaotrs lights to show the selected source.
TAPE 2 MONITOR
When a cassette tape deck is connected to the TAPE 2 jacks,
use this button to turn on or off the tape monitor function.
The indicator lights when the tape monitor function is on.
MUTING
Use this button to mute the sound.
This indicator blinks during the muting.
VOLUME
Turn this knob (or press the VOLUME buttons of the remote
control unit) to adjust the volume.
MIC Jack and MIC LEVEL knob
With the microphone plugged into this jack, the sound picked
up from the microphone will be heard together with the
source sound selected by the INPUT SELECTOR.
Turn the MIC LEVEL knob to adjust the input level of the
microphone.
LOUDNESS
Use this button to compensate for the loss of bass at low
volumes.
BALANCE
Use this knob to adjust the balance of the speakers.
Normally, set the knob to the center position.
SOURCE DIRECT
Press this button to turn on or off the source direct function.
When the source direct function is set to on, the button lights
and you can listen to the sound without tone effects.
TREBLE
Use this knob to adjust the level of high frequency
information.
L
K
J
I
H
G
F
E
D
C
The equipment draws nominal non-operating power from
the AC outlet with its POWER switch in the OFF position.
B
A
BASS
Use this knob to adjust the level of low frequency
information.
SPEAKERS buttons
Use these buttons to turn on or off the speakers.
on : Sound is output from the speakers.
off : No sound is output from the speakers.
PHONES jack
For private listening, insert the headphones plug into this jack,
and adjust the volume by turning the VOLUME knob.
Remote Control Unit
ON
When the POWER switch of the main unit is depressed, use
this button to turn the unit on.
STANDBY
When the POWER switch of the main unit is depressed, use
this button to turn the unit standby.
Buttons for the operation of TEAC’s CD player
Buttons for the operation of TEAC’s cassette tape deck
Use these buttons to operate TEAC components with
mark.
Buttons for the operation of TEAC T-R610 (TUNER).
Numeric buttons:
Use these buttons to select a preset channel.
Note:
<
To simplify explanations, instructions in this manual refer to
the names of the buttons and controls on the front panel
only. Associated controls on the remote control will also
operate similarly.
e
d
c
b
a
O
N
M