Quatech Serial Device Server - Manual (Page 53)

Quatech SDS User’s Manual Configuring the SDS using a Web interface
Setting network parameters
Once you have made the initial network connection, you can maintain
and configure this connection using Quatech’s Web interface. Of
course, you can always go back and use the Installation Wizard to
program the settings for the SDS. Contact your network
administrator if you are unsure of any of these settings.
Note: If you inadvertently lose
contact with the SDS, use the
Installation Wizard to re-establish
contact.
See Setting TCP/IP (LAN) and Wi-Fi (Wireless) parameters below or
see Setting SNMP parameters on page 52. Note: To setup for a Wireless
(Wi-Fi) SDS, you must first
connect to it using the wired
Ethernet mode. See Enabling
Wi-Fi Device Servers on page
14 for details.
Setting TCP/IP (LAN) and Wi-Fi (Wireless) parameters
Step Procedure Description
‰
Preliminary
Step
Click on Network in the selection bar. The Network Setup screen shown on
the following page displays.
July 2005 940-0183-153 Page 47