Quantum Audio drive DDS-4 - Manual (Page 20)

Installing internal tape drives Reviewing Drive Default Settings
20
FIGURE 3. Internal Tape Drive Jumper Settings
TABLE 2. Internal Tape Drive Default Settings
Parameter Default Setting Jumper Pins/Switches See...
SCSI ID 6 Jumper pins 1–2, 3–4, 5–6, 7–8 page 21
Parity checking Enabled Jumper pins 9–10 page 22
Terminator power Disabled Jumper pins 11–12 page 22
Data compression Enabled Switches 1 and 2 page 23
Media Recognition System checking
(DDS-4 drives only) Enabled Switch 3 page 23
Power-On Self-Test diagnostic Enabled Switch 4 page 24
Host operating system Microsoft Windows
98/Me/XP/NT/
2000/2003 Server Switches 5 through 8 page 24
SCSI interface compatibility
(DDS-4 drives only) Wide SCSI (LVD
and single ended) Switch 9 page 25
Vendor ID SEAGATE DAT Switch 10 page 25
SCSI ID=0
SCSI ID=1
SCSI ID=2
SCSI ID=3
SCSI ID=4
SCSI ID=5
SCSI ID=6
SCSI ID=7
SCSI ID=8
SCSI ID=9
SCSI ID=10
SCSI ID=11
SCSI ID=12
SCSI ID=13
SCSI ID=14
SCSI ID=15
Parity enable
Term. power
Default jumper settings shown
(SCSI ID 6, parity checking enabled,
and termination power disabled)
Pins: Function:
1-2 SCSI ID bit 0
3-4 SCSI ID bit 1
5-6 SCSI ID bit 2
7-8 SCSI ID bit 3
9-10 Parity checking
11-12 Termination Power