Oregon Scientific JUMBO RF WALL CLOCK WITH NIGHT SENSOR NR868 - Manual (Page 7)

6
EN
Calendar /
Clock / Sec Calendar /
Clock / Day Calendar / Clock /
Offset Time
SYMBOL LANGUAGE
English
German
French
Italian
Spanish
CLOCK / CALENDAR
CLOCK / CALENDAR DISPLAY
There are 3 types of clock display:
HOURLY CHIME
The hourly chime function when set to ON will beep
once at the beginning of every hour, and the chime
icon
will show on the display.
TEMPERATURE
To choose between °C / °F, slide the switch up or
down to the setting you want.
The display can show indoor temperatures ranging
from -5°C to +50°C (23°F to +122°F).
ALARM
ALARM DISPLAY
There are 3 types of alarm display:
Press the ALARM button to toggle between the 3 types
of display.
Press the MODE button to toggle between the 3 types
of display.
SETTING THE CLOCK / CALENDAR
Before you can manually set the clock and calendar,
you must specify the current time zone you live in
and the time format (12- or 24-hour) as follows:
1. Press and hold the MODE button for 2 seconds.
The time zone offset hour digits will flash. When
an offset hour has been set (e.g. +1, the time
displayed will be the RF clock time plus 1 hour.)
2. Enter the value by pressing the or buttons.
3. Confirm the entry by pressing the MODE button.
The 12- or 24-hour display format will flash.
4. Repeat (2) and confirm the entry by pressing the
MODE button.
5. Repeat the above procedures to set the hour,
minute, year, MM / DD or DD / MM format, month,
day, day-of-the-week language and hourly chime
(On / Off).
You can select 1 of the 5 following languages:
Daily Alarm /
Clock Start Time
for Backlight
activated by
Nightlight Stop Time for
Backlight
activated by
Nightlight
IMPORTANT When you press and hold ALARM for 2
seconds to enter the Setting Mode you need to make
sure you are in the correct alarm display (see above
for reference).
SETTING THE ALARM
To set the alarm:
1. Press and hold the ALARM button for 2 seconds
when the selected alarm is displayed. The hours
will flash.
2. Enter the values by pressing or .
3. Confirm the entry by pressing the ALARM button.
4. The minutes will flash.
5. Repeat (2) and (3) to finish the setting. The alarm
will be activated automatically and the alarm icon
will appear on the display.