Oricom DECT MI40 - Manual (Page 12)

23 of 72
• To turn off the ringer volume, press on VOL OFF. The icon
on the display will be turned on.
•
You can also press and hold during phone ringing or
standby to turn off the ringer. The icon on the display will be
turned on. To turn on the ringer, user can press and hold
during phone ringing or standby. The icon on the display will
be turned off.
Adjusting the Receiver Volume
During a call, user can adjust the receiver volume by pressing .
There are 3 levels of receiver volume to choose from: , & .
•
Press , the current volume level is displayed.
• Press to increase the volume.
•
Press to decrease the volume.
Handsfree Operation
Using the Handsfree Speaker
• Press for handsfree operation during a call.
•
The earpiece is turned off and the speaker is turned on. You
can now talk into to the microphone without holding the
handset to the ear.
•
Press again. The speaker is turned off and the earpiece
is turned on. You will need to hold the handset against the
ear.
Using a Headset (Not supplied)
• Gently flip back (do not remove) the rubber cover on the side
of the handset to gain access to the headset socket.
• Plug the headset into to the headset socket.
24 of 72
•
The handset receiver and microphone are now turned off.
•
You can now talk into to the microphone of the headset
without holding the handset to the ear.
• For additional mobility and full handsfree, mode clip handset
to your belt using the clip supplied.
Microphone Mute / Un-mute
During a call, User can mute the microphone by pressing
The icon on the display will turn on. To un-mute, press again.
The icon on the display will turn off.
Handset Locator (page function))
In the event of misplacing the handset, briefly press the button on
the base unit will page all handsets. All handsets on standby will ring
for 30 seconds. The
icon and the prompt BS PAGING will be
blinking on the display. User can press any key on a handset to stop
the paging. Note: If you press and hold the page key for more than 4
seconds, the phone will enter into registration mode.
Handset Keypad Lock/Unlock
You can lock the handset to prevent pressing any keys accidentally.
When the keypad is locked, all keys will be inactive.
To lock:
• Press and hold during standby.
•
The display will show HOLD #.
To unlock:
•
Press and hold during standby.
Note: When a call comes in, user can answer the call by pressing
if the handset is not on cradle or lift the handset from the cradle