Oricom BB200 - Manual (Page 9)

- 9 -
HANDSET RINGER VOLUME
•
While the handset is in the standby mode press the volume button.
•
Press the to decrease the volume level and to increase the volume level.
The display shows the current volume level: the less “0’s” is the lowest level and
more “00000” is the highest level.);
the
% symbol indicates the ringer is turned off.
•
Press the button again to confirm, otherwise wait a few seconds for the new
setting to be automatically confirmed and the display to get back to standby mode.
HANDSET RINGER MELODY
You have a choice of 9 ringing melodies.
•
While the handset is idling (not busy on a call) press the button and hold it for
about 3 seconds, the display shows “d--d” followed by the number (1-9) current
ringer melody.
•
Press the or button briefly to hear the different ringing melodies.
•
When you reach the melody you prefer press the button again to confirm,
otherwise wait a few seconds for the new setting to be automatically confirmed and
the display to get back to standby mode.
TO MUTE THE MOUTHPIECE
To put the call on hold, so that the person on the other end cannot hear you, press the
DEL button briefly. While the mouthpiece is muted
x is shown on the display.
To return to the call press the DEL button again.
TO LOCK THE KEYPAD
To lock the handset’s keypad so that no buttons can be pressed.
To block the handset keypad, while handset is idle press #/
and hold it for a few
seconds; until you hear a confirmation beep and appears on the display.
To unlock the keypad, press #/
again and hold it until disappears from the display.
USING YOUR CORDLESS ON A OFFICE PHONE SYSTEM (PBX)
PAUSE FUNCTION
If you have connected this phone to an office phone system (PBX) you may need to
enter a pause for a few seconds between dialling the line access code and the actual
phone number. To enter a 3 second pause, press the
button and a dash “ - “will
appear in the display.