Oricom BB200 - Manual (Page 8)

- 8 -
PRE-DAILLING
Pre-dial allows you to enter a telephone number and verify it on the screen before you
place the call. The screen displays the last 12 digits dialled but you can enter up to 2
digits.
•
In standby mode enter the phone number you wish to dial.
•
To enter a pause, press the button and a dash “-“will appear in the display.
•
If you make a mistake, press DEL to erase one digit at a time. Or you can press
and hold the DEL button to clear the entire number and return the phone to standby.
•
Press to dial out the number.
•
To end the call, press the button again, or replace the handset back in the base.
Note: If you have connected this phone to an office phone system (PBX) you may need
to enter a pause for a few seconds between dialling the line access code and the
actual phone number.
To pause, press the button and a dash “ - “will appear in the display.
LAST NUMBER REDIAL
You can review and call back the last 3 numbers you have dialled as your cordless
stores them in the redial memory.
•
In the standby mode press the button to scroll through the last 3 numbers you
dialled.
•
Select the number you want to redial and press , to dial the number.
CALL DURATION TIIMER
When you make or answer a call the display shows the call duration in time minutes
and seconds.
ADJUSTING THE EARPIECE VOLUME
During a call, to adjust the volume in the handset’s earpiece or speakerphone press
the volume button repeatedly
.
The display shows the current volume level: the more “0’s” the highest the volume (“0”
to “00000”).
TO PAGE THE HANDSET
This function is useful if you can’t find your handset.
•
On the base unit press and release the button. The handset rings with a special
tone.
•
To stop the handset ringing, on the handset press any button or numbered key.