Oricom BB200 - Manual (Page 6)

- 6 -
INSTALLATION
POWER SUPPLY
IMPORTANT!
The mains power adaptor must be installed near the equipment and must be easily
accessible. Power must be turned on at all times for the phone to work
1. Connect the output plug of the mains adaptor to the adaptor socket on the back of
the base unit and the mains adaptor to the wall mains supply.
2. Connect the telephone lead to the phone cord socket on the back of the base unit
and to the wall phone socket.
FITTING BATTERIES
IMPORTANT: Only use the rechargeable batteries provided with this phone.
1. Place your handset with the keypad facing downwards.
2. Remove the battery compartment cover by pushing on the indent and sliding it in
your direction.
3. Insert the two batteries (AAA) into the battery compartment, observing the correct
polarity.
4. Slide the battery compartment cover gently back into place, it will click when it is in
the correct position.
IMPORTANT!
PLACE THE HANDSET IN THE BASE UNIT AND LEAVE FOR 15 HOURS TO
CHARGE THE BATTERIES FULLY BEFORE FIRST USE.
RECHARGING YOUR CORDLESS PHONE
When your handset battery becomes low the Low Battery symbol appears on the
display. To recharge it, just replace the handset on the base unit.
Tip! It is good practice to put the handset on the base unit to charge when it is
not in use or every evening to ensure the handset is always fully charged
REPLACING BATTERIES
CAUTION
THERE IS A RISK OF EXPLOSION IF THE BATTERY IS REPLACED BY AN
INCORRECT TYPE. Never use non-rechargeable batteries; use only type
supplied with this telephone. Ni-MH batteries must be disposed of in
accordance with the applicable waste disposal regulations. When the handset
needs to be charged more frequently, even when batteries are correctly recharged, it is
time to replace the batteries: follow the instruction above “Fitting Batteries”.