Onkyo TX-8555 - Manual (Page 37)

37
Zone 2—Continued
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the receiver
Notes:
• While Zone 2 is on, the Auto Power On/Standby and
Direct Change functions do not work.
• When you control Zone 2 with the remote controller
while main room is standby, the display doesn’t work.
Controlling Zone 2 with the Remote
Controller
Using Zone 2
1 To turn on Zone 2 and select an
input source, press the [ZONE 2]
button repeatedly.
Alternatively, press the [ZONE 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on and ZONE 2 indicator
lights up.
To select the same source as that of the
main room, press the [ZONE 2] button
repeatedly until “Zone 2 Sel: Source”
appears.
To select AM or FM, press the
[TUNER] Input Selector button
repeatedly. On the North American
model, you can also select
XM/SIRIUS.
Note:
• You cannot select different AM or
FM radio stations for your main
room and Zone 2. The same AM/FM
radio station will be heard in each
room.
2 To turn off Zone 2, press the Zone
2 [OFF] button.
ZONE 2 LEVEL/TONE
OFF
ZONE 2
1 Press the [ZONE 2] button, then
point the remote controller at the
receiver and press the
[ON/STANDBY] button.
Zone 2 turns on and ZONE 2 indicator
lights up.
2 To select an input source for
Zone 2, press the [ZONE 2]
button, followed by an Input
Selector button.
To select AM or FM press the
[TUNER] Input Selector button
repeatedly. On the North American
model, you can also select
XM/SIRIUS.
Note:
• You cannot select different AM or
FM radio stations for your main
room and Zone 2. The same AM/FM
radio station will be heard in each
room.
ON/STANDBY
ZONE 2
/
MUTING
VOL
Input
selector
buttons