beautypg.com

Activating the batteries, Reset the timer, Select the preferred language – Orbit Manufacturing Fluid 57926 User Manual

Page 6: Set the time of day and date

background image

5

ENGLISH

Activating the Batteries

• Slide the docking port off the timer unit to gain access to the
battery compartment door.

• Slide the door off the battery compartment in the direction
of the arrow.

• Remove the black strip from the battery compartment.

• Replace the battery compartment door.

• Slide the docking port back onto the main controller unit.

The display will show “LOW BATTERY” when it is time to
replace the batteries.

NOTE: Batteries alone will not operate the valves in your sprinkling
system. The transformer must be plugged in and have power to oper-
ate your system normally.

Reset the Timer

If this is the first time the sprinkler timer has been pro-
grammed, you should press the small recessed button labeled

RESET

(located under the

RAIN DELAY

button). You will prob-

ably need a pen, pencil or similarly small object to push it.

Do not press the

RESET

button again unless you want to com-

pletely remove all your programming, including time and date.

If no programming occurs after the

RESET

button has been

pressed and the dial is left in the

AUTO

position the timer will

assume a default program mode. In default mode, the timer will
automatically water each station for 10 minutes, beginning at 5
a.m. each day.

Select the Preferred Language

• Turn the selection dial to

BUDGETING/LANGUAGE

.

• Press the

RAIN DELAY

button.

• Press the

NEXT

button until the desired language is

shown in the display.

• Exit the language selection mode by turning the selection dial
or pressing the

RAIN DELAY

button.

Set the Time of Day and Date

If this is the first time the timer has been programmed, press
the small recessed

RESET

button.

• Turn the selection dial to

TIME/DATE

.

• The top line of the display reads “SET TIME.” Set the current
time by pressing either the or button.

NOTE: To move faster through the time or other selections, hold the
or buttons down, rather than merely pressing and releasing.

• Press the

ENTER

button. The display now reads “SET

YEAR.” Set the current year by pressing either the
or button.

07WTM002598 57926-24 rA.indd 5

2/16/07 2:07:19 PM