Orbit Manufacturing Fluid 57926 - Manual (Page 5)

4
Programming Buttons
These nine buttons are used for programming and other
operations:
A RF Sync (only on remote control model)
Allows the timer to synchronize with a new remote or wire
less sensor.
b Rain Delay
Push this button once while in AUTO to access the rain
delay option. NOTE: Pressing this button will access the
Language and No Watering Period options while in those
respective dial positions.
c Reset (pin hole)
Resets the timer to its factory settings.
d Increase
e Decrease
f Enter
g Next
h Clear
i Manual
Selection Dial
This dial is used for programming, reviewing and operating the
sprinkler timer.
Rain Sensor Bypass Switch
In Active position the controller will monitor the rain sensor, in
Bypass position the controller will ignore the rain sensor. (This
switch is for hard wired sensors only and does not effect wireless
rain sensors - sensors sold separately).
About This Manual
We have added the following features to this manual to assist
you:
• BLUE TEXT relates to the buttons used for programming.
• BLUE UNDERLINED TEXT relates to stop positions for the
selection dial.
• A glossary of the most common terms is included.
(see page 16)
Section 2: Getting Started
You can program this sprinkler timer in just a few basic steps.
Before you begin programming, it is important to:
• Activate the batteries
• Reset the sprinkler timer
• Select the preferred language
• Set the time of day and date
• Determine a watering plan
RF SYNC
ACTIVE BYPASS
NO W AT ER IN G
DA Y / PE RI OD
Figure 1: Front view of timer
d
e
f g
h
i
07WTM002598 57926-24 rA.indd 4 2/16/07 2:07:19 PM