One Stop Gardens 98197 User Manual

Page 7

Page 7

SKU 98197

for technical questions, please call 1-800-444-3353.

Head Bolt (63)

and Lock Nut

(80)

Lower Hopper

Tubes (10/11)

figure 8

3. Attach the two Lower Hopper Tubes

as shown in Figure 8. Secure in

place with Curved Head Bolt (63) and

Hex Lock Nut (80) as shown in as-

sembly diagram.
Set the assembled Lower Hopper

Tubes (10/11) onto the bottom of the

Hopper Bag (12).
Secure the Upper and Lower Hop-

per Tube ends together with two Hex

Bolts (61) and Hex Lock Nut (57). Do

not overtighten.
Assemble the Bag Frame Stamp (49)

and Skirt Retainer (43) to the front

edge of the bag bottom. Set the Skirt

Retainer (43) on top and the Frame

Strap (49). Secure with six Screws

(52) and Lock Nuts (53).
Attach the Bag Frame Strap (49) to

the lower hopper frame. Secure with

Hex Bolt (61) and Lock Nut (57).
Set the bag corners over the lower

hopper tube. Snap the bag bottoms

closed with snaps on bag.
Note: Hopper Support Rods are steel

and require force to bend or bow. Ex-

cercise caution and do not over bend

as this will cause a loss of necessary

tension. Set each of the two Hopper

Support Rods (50) by placing the top

end of each rod into the hole in the

Upper tube. Bend the Hopper Sup-

port Rod outward and snap the bot-

tom end of the Hopper Support Rod

(50) into the hole in the Lower Hop-

per Tube (11).
Locate the hole along the side of

10.

the Upper Hopper Tubes. Align the

Hopper Bag (12) with the hole in the

Upper Hopper Tube. Pierce a hole

through the Hopper Bag at the point

it is aligned with the Upper Hopper

Tube.

Clevis Pin (58)

ock Nut (55)

Bolt (56)

Mount

Clamp (64)

Bag Retainer

Clevis (66)

Cotter

Pin (62)

figure 9

11. Secure the Mount Clamps (64) to

each side of the Upper Hopper

Tubes (9). Place one Clevis Pin (58)

through the Mount Clamps (64), the

Hopper Bag and the Upper Hopper

Tubes (9). Secure with Hex Bolts

(56) and Lock Nuts (55)-see Figure

9. Repeat for second side.
Secure the Bag Retainers with Clevis

12.

Pins (58) and Cotter Pin (62). Wrap

Cotter Pin around Clevis Pin as

shown in Figure 9.
Secure the Rope (78) to the top cen-

13.

ter of the Hopper Bag Frame.
Secure the Wind Screen (31) to the

14.

Upper Hopper Tube (9). Stretch out

all four corner loops and snap into