One Stop Gardens 98197 - Manual (Page 6)

Page 6 SKU 98197 for technical questions, please call 1-800-444-3353.
using Bolt (29) and Lock Nut (54)-see
Figure 5.
Secure the round hole end of the
11.
Height Adjustment Strap (6) to the
Angle Bracket (38). Place a Bushing
Spacer (30) over the end of the Slot
Head Bolt (71) and into the hole in
the Adjustment Strap (6)-see Figure 5
and Assembly Diagram. Secure with
Lock Washer (44) and Hex Nut (28).
Finish securing Height Adjustment
12.
Strap (6) to Height Adjustment Han-
dle. Place the slot on the Height Ad-
justment Strap in line with the square
hole. Secure in place with Carriage
Bolt (29), Washer (54) and Knob (5).
Hex Bolt (73)
Bag Mount
Arm (48)
Lock
Nut (60)
figure 6
13. Attach both Bag Mount Arms (48) to
the outside of the housing with Hex
Bolts (73) and Lock Nut (60). Note
that the notches in the Bag Mount
Arms (48) must face upward and Bag
Mount Arms must be attached to the
outside of the housing-see Figure 6.
Hitch Pin
Hitch Bracket (47)
Cotter
Pin (75)
Spacers (77)
figure 7
14. Insert two Spacers (77) between
Hitch Bracket (47) and Hitch Tongue
(65). Insert Hitch Pin (76) down
through the Hitch Bracket, Spacers
(77) and through Hitch Tongue (65).
Secure with Cotter Pin (75)-see Fig-
ure 7.
Hopper bag assembly
Starting at the center cut in the top of 1.
the Hopper Bag (12), insert the Left
Hand Upper Hopper Tube (9) through
the hopper bag stitched tubes. Re-
peat for the Right Hand Upper Hop-
per Tube (8).
Slide the two Upper Hopper Tubes
2.
(8/9) together. Make certain that the
center holes line up perfectly. Secure
in place with Curved Head Bolt (63)
and Hex Lock Nut (80) as shown in
assembly diagram.