Onkyo TX-DS474 - Manual (Page 23)

23
Using preset radio stations
GROUP
GROUP √ PRESET ®
TUNER
√ PRESET ®
SCAN
POWER SLEEP DIMMER SUR MODE
VIDEO-1 VIDEO-2
TAPE DVD C D
C D DVD
TUNER
TUNER
PHONO INPUT SELECTOR
DISC
TAPE
VOLUME LEVEL
CH SEL
PRESET
MUTING
TEST TONE
MULTI-CH INPUT
REMOTE CONTROLLER
GROUP
RC-385S
BASS TREBLE
C D PHONES
DIMMER
AUDIO VIDEO CONTROL RECEIVER TX-DS 474
SCAN GROUP
AM FM DVD PHONO 1 VIDEO 2 VIDEO TI CH INPUT MUL TAPE( ) MONITOR
STANDBY
TUNING PRESET PARAMETER CONTROLLER
PARAMETER SELECTOR
CLEAR
MEMORY FM MUTE / MODE SPEAKERS A B MIDNIGHT THEATER SURROUND MODE
MASTER VOLUME
HIGH CURRENT DISCRETE OUTPUT STAGE AMPLIFIER
OFF ON
POWER
STANDBY/ON
√ TUNING ®
FM MUTE/MODE
MEMORY
AM
FM
1. Select the frequency that you want to store in the memory.
(See Tuning in a radio station on page 22.)
2. Press the MEMORY button.
The MEMORY indicator will light up for eight seconds.
3. While the MEMORY indicator is lit, press the GROUP but-
ton to choose the desired group.
The group shown on the display changes in the following order
each time the button is pressed:
4. Select the desired memory number using PRESET √/®
button.
5. Press the MEMORY button.
•
Since ten AM or FM stations can be stored in each group (A, B
or C), a total of 30 stations can be stored in the memory.
1. Select the tuner as the source by pressing the AM or FM
input selector button on the main unit.
2. Press the GROUP button until the desired group is dis-
played.
3. Enter the desired preset number using the PRESET √ and
® buttons or press the SCAN button to scan through the
preset stations.
If the SCAN button is pressed, each station stored in the
selected group will be played for five seconds. When the desired
station is found, press the SCAN button again to stop scanning.
Remote controller operation
1. Select the tuner as the source by pressing the TUNER input
selector button on the remote controller.
2. Press the GROUP button until the desired group is displayed.
3. Press the PRESET (√ or ®) button.
1. Select the preset station you wish to remove as explained in
the previous section.
2. Press the FM MUTE/MODE button while holding down the
MEMORY button. “– –” appears on the channel display.
•
Once the preset station has been cancelled, the memory location
can be used to store another station.
Programming radio stations
Selecting a preset station
Cancelling preset stations
GROUP A GROUP B GROUP C
SPEAKERS A GROUP FM STEREO
B
CH MHz
VIDEO 2
TUNED FM MUTE
PRESET
SPEAKERS A GROUP FM STEREO
A
CH MHz
VIDEO 2
TUNED FM MUTE
MEMORY
CLEAR
MEMORY FM MUTE / MODE
GROUP SPEAKERS A FM STEREO
B
CH MHz
VIDEO 2
TUNED FM MUTE
MEMORY
SCAN GROUP
2
3
4
5
CLEAR
MEMORY FM MUTE / MODE
SCAN GROUP
Remote controller
GROUP
AM FM
Remote controller
TUNER
1
2
3
SCAN GROUP
Remote controller
PRESET
or
PRESET
CLEAR
MEMORY FM MUTE / MODE SPEAKERS A GROUP FM STEREO
B
CH MHz
VIDEO 2
TUNED FM MUTE