beautypg.com

End panel layouts – Orion Car Audio HCCA COMPETITION HCCA10002 User Manual

Page 4

background image

© 2009 Directed Electronics. All rights reserved.

3

END PANEL LAYOUTS

HCCA10002

ESP

REMOTE

GAIN

L

INPUT

R

INPUT

L

OUTPUT

R

OUTPUT

L CH

R CH

1

2

3

4

6

5

BRIDGE 4 OHM

HCCA10004

6

1

7

8

4

9

10

11

12 13

ESP

RF

R

RR

LF

INPUT

GAIN

RANGE

CH

MODE

LINE

OUT

L

OUTPUT

LR

INPUT

LF

RF

LR

RR

HIGH
LOW

2 CH
4 CH

F/R SUM
PASS

REMOTE

GAIN

BRIDGE 4 OHM

BRIDGE 4 OHM

ESP

1.

- Allows connection of a Directed ESP controller, like the

Bitwriter.

Speakers

2.

(Left channel)

(HCCA10002 only, refer to the Speaker Connections section of
this guide.)

Input -

3.

Accepts RCA input from a head unit, preamplifier, or

equalizer (HCCA10002 only).

RCA Line Output -

4.

Provides easy connection to additional ampli-

fiers, the RCA inputs and RCA output are the same signal and are
not affected by any amplifier functions.

Speakers

5.

(right channel) - HCCA10002 only see item 2

Remote Gain Input -

6.

Connects optional RGC2 remote gain control

to control the gain level from the driver’s seat.

GAIN RANGE -

7.

Selects the input sensitivity range to either High

(for high power head units) or Low (for line level head units).

Speakers

8.

(Left Front and Right Front below)

ers to these terminals. (HCCA10004 only, refer to the Speaker
Connections
section of this guide.)

Input

9.

(Left Front and Right Front below) - Accepts RCA input from

a head unit, preamplifier, or equalizer (HCCA10004 only).

Input

10.

(Left Rear and Right Rear below) - see item 9

Speakers

11.

(Right Rear and Left Rear below)

2/4 Channel Switch -

12.

2ch setting will allow 4 channel output with

a signal only present on the front inputs. 4 ch will allow a 4 chan-
nel output when signal is present on the front and rear inputs.

Front/Rear Sum Switch -

13.

Allows you to sum the front and rear

channels together before sending the signal out the RCA line out.
If the switch is not engaged, then only the front left and front
right signals are sent to the RCA line out.

Figure 1
Figura 1

Abbildung 1

Figure 2
Figura 2

Abbildung 2

This manual is related to the following products: