Orion Car Audio HCCA COMPETITION HCCA10002 - Manual (Page 15)

© 2009 Directed Electronics. All rights reserved. 14
Five Channel Configuration
Channels 1/2 are configured for 2-channel stereo operation. s
Channel 1/2 lowest recommended impedance is 2 s Ω stereo. Lowest
recommended impedance is 2 Ω stereo and 4Ω bridged mono.
Rear outputs must be set for full range operation. s
Passive crossovers must be used on all components and frequen- s
cies must not overlap.
RR
LR LF
RF
Figure 19
Figura 19
Abbildung 19
NOTE:
shown in this diagram may need to be used to prevent the impedance
from dropping too low and engaging protection circuits.
Tri-Mode Six Channel Configuration
Lowest recommended impedance is 2 s Ω stereo and 4Ω bridged
mono.
Front and rear outputs must be set for full range operation. s
Passive crossovers must be used on all components and frequen- s
cies must not overlap.
WARNING! Failure to observe these requirements may result in dam-
age to the amplifier.
RR
LR
RF
LF
Figure 20
Figura 20
Abbildung 20
NOTE:
shown in this diagram may need to be used to prevent the impedance
from dropping too low and engaging protection circuits.