Orion Car Audio HCCA COMPETITION HCCA10002 - Manual (Page 13)

© 2009 Directed Electronics. All rights reserved. 12
3PEAKER
The Orion HCCA10002 amplifier offer one positive and one negative
output terminal for ease of connecting channel 1(L CH) and/or 2(R CH)
outputs to the speakers. The amplifier is stable to 2
Ω per channel. See
diagrams below.
One Channel/Two Channel Configuration
Lowest recommended impedance is 2 s Ω stereo.
Outputs can be configured for high-pass, low-pass, or full range s
operation.
Figure 14
Figura 14
Abbildung 14
L CH
+
_
+
_
R CH
Bridge Configuration
Bridging allows one speaker to be driven at a higher power level from
the amplifier.
The bridged outputs lowest recommended impedance is 4 s Ω.
Figure 15
Figura 15
Abbildung 15
L CH
+
_
+
_
R CH
Three Channel (L Channel, R Channel, Bridged)
Left and Right are configured for two-channel stereo operation. s
Lowest recommended impedance is 2 s Ω stereo.
The third output is configured for a single channel bridged out- s
put.
The bridged outputs lowest recommended impedance is 4 s Ω.
Outputs are configured for high-pass, low-pass, or full range s
operation.
Figure 16
Figura 16
Abbildung 16
L CH
+
_
+
_
R CH
NOTE:
shown in this diagram may need to be used to prevent the impedance
from dropping too low and engaging protection circuits.