Omnitron Systems Technology Universal DIN Rail Mounting Bracket 8250-0 User Manual
Page 2
k
m
m
m
i
[A] and [D]
[B]
[C]
n
n
Converter
Front Cover
Screw
i
[B], [C] and [D]
[A]
i
i
k
k
STEP 2. Optional Orientation Reconfiguration
If the desired mounting orientation is other than [B] as illustrated in Fig. 2,
remove the DIN Rail clips (
k
) from the bracket by removing the DIN Rail clip
screws (
m
). Determine the desired DIN Rail mounting orientation from the
Figure 2, and match the corresponding DIN Rail clip orientation in Figure 4.
Attach the DIN Rail clips (
k
) to the DIN Rail bracket holes in the DIN Rail
Bracket (
i
) and secure the DIN Rail clips (
k
) with DIN Rail clip screws (
m
).
Figure 4. Configuring Clip Mounting Orientation
STEP 3. Attaching Bracket to Converter
Remove the rear cover screws from the media converter casing. Align the
media converter to the bracket mounting holes that correspond with desired
orientation, then insert and fasten the supplied bracket mounting screws (
n
)
to secure the media converter to the DIN Rail bracket (
i
).
Figure 5. Attaching Bracket to Converter
Form: 040-08250-001B 9/07
Patent Pending
DIN Rail
Cross Section
Close Up
Tab on the
DIN Rail Clip
Hooks on the
DIN Rail Clip
TECHNICAL SUPPORT:
For help with this product, contact our Technical Support:
Omnitron Systems Technology, Inc.
Phone: (949) 250-6510 Fax: (949) 250-6514
Address: 140 Technology Dr., #500 Irvine, CA 92618 USA
Email: [email protected]
URL: www.omnitron-systems.com
STEP 4. Mounting Converter to the DIN Rail
Attach the assembly to the DIN Rail, by aligning the hooks on the DIN Rail clip
(
k
) to the upper edge of the DIN Rail. Rotate the assembly downward until the
DIN Rail clip tab engages and snaps to the bottom edge of the DIN Rail. Note
that the tab on the DIN Rail clip should always attach to the bottom of the DIN
Rail. Connect the external power supply to the rear of the installed media
converter.
Figure 6. Mounting/Dismounting Converter to/from DIN Rail
Dismounting from DIN Rail
To remove the converter assembly from the DIN Rail, hold the converter and
rotate upward to disengage the clip.
Mount
Dismount