Orange Micro Interface The Grappler - Manual (Page 16)

APPENDIX B
DIP SWITCH SETTINGS FOR YOUR PRINTER
All printers must configure to a Centronics type psrallel interface.
ANADEX 95ШШ — 93Ш1
All switches on S—3 must be off. Set switches on S-1 snd S—2 appropriately.
CENTRONICS 739—1
All four switches oust be off.
EPSON MX-7Ø
Shorting plug must be hooked up to the red post for no auto—line feed.
EPSON NX—8Ø; NX—SOFT with Graftrax—8Ø
All switches on S-2 should be off. Dip switch S-l, switch 8 must be on and
switch 3 must be off.
EPSON MX-1ØØ
S—2
switch 3 must be off
S—1 switch 6 must be off and switch 8 must be on.
I.D.S. 44ØG — 445G
S—4
switches 5, 6 and 7 Must be off
S—3 switches 6 must be on and switch 7 must be off
Strapping for 44ØG — 445G (locate beside I.D.S. cable connector)
9-6 - busy active when high
11-5 — strobe data on positive edge
14—1 — always remain installed
I.D.S. 46ØG — 56ØG
S-4
switch 5 must be off and switch on
S—3 switches 6 and 7 off
Strapping for 46ШШ—56ШШ (locate beside I.D.S. cable connector)
Must be strapped as shipped.
8—7 installed for parallel
11—4 installed for busy rising high
12—3 installed for negative going strobe
*Note: All switches not mentioned can be set as user desires
—15—