Orange Micro 9210286 - Manual

007-4492-001 1
Gasket Attachment Instructions for Orange Micro ® USB Card
The following instructions describe how to attach an EMI gasket to an Orange Micro USB
card. This USB card is used in graphics systems that require a USB keyboard and mouse.
To attach the EMI gasket, you need the following items:
• One Orange Micro USB PCI card (P/N 9210286)
• One gasket (P/N 042-1243-001)
• Two USB type A connectors (for alignment)
Note: If you do not have any USB connectors, you will need to visually align the EMI
gasket with the USB card.
Before the gasket can be attached to the USB card, the card must be installed in your system.
For instructions on how to install the Orange Micro USB card, see the PCI card installation
section of your system user’s guide.
To attach the gasket, follow these steps:
1.
Remove the protective adhesive tape from the EMI gasket.
2. To ensure proper alignment of the gasket to the USB card, insert a USB connector into
a cutout at each end of the gasket, as shown in Figure 1. Make sure that you insert the
connector starting on the non-adhesive side of the gasket, and that the orientation of
the connector is in the correct position to mate with the connector on the USB card.
3. With the pointed end of the gasket positioned to the left, insert the two USB
connectors into the mating connectors on the USB card.
Figure 1 Inserting Two Type A USB Connectors
Adhesive
tape
EMI gasket
Position point
to the left
Non-adhesive
side of gasket
Orange Micro
USB card