One Stop Gardens Greenhouse 44712 - Manual (Page 8)

Page 8 For technical questions, please call 1-800-444-3353. Item 47712
Frame Assembly
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
• Unless noted otherwise, attach all frame parts using the Bolts (43) and Nuts (52) provided.
Tighten nuts only about 1 /
4
turn past finger tight; be careful not to overtighten.
• Lay out all parts by number prior to assembly.
• Use an assistant or an appropriate support (not included) to keep the partially assembled parts upright
during assembly. Use two assistants to assemble the Crown pieces to the rest of the frame.
• Assemble on a clear, calm day. Wind will damage the Greenhouse and make assembly difficult.
Assembling the Frame Edges
(Front)
(Rear)
(Right)
(Left)
Side
Ceiling
Plate (36)
Figure G: Frame Edges
1. There are four Corner Studs (1) to be
attached to the four Floor Plates (16, 17, 34).
Attach one Corner Stud (1) on the outside of
each corner. Attach an End Cap (47) to the
top outer corner of each Corner Stud (1).
2. Once the four Corner Studs (1) are connected to the
Floor Plates (16, 17, 34), drill three pilot holes 1 1 /
2
″
through each Floor Plate and into the underlying
wood sill or base. Make sure not to drill into any of
the hardware used earlier. Then, secure the Floor
Plates to the foundation, using three 1 1 /
2
″ long wood
screws (sold separately) for each Floor Plate.
SAFETY
FRAME
MAINTENANCE
FOUNDA
TION