beautypg.com

Front & rear panels, Front panel – Onkyo PA-MC5500 User Manual

Page 8

background image

8

Front & Rear Panels

POWER switch
This is the main power switch. When set to OFF,
the amplifier is completely shutdown. It must be set
to ON to set the amplifier to On or Standby.

ON/STANDBY button
This button is used to set the amplifier to On or
Standby.

Note:
If you wish to turn on the amplifier again after it is turned
off, wait for several seconds.

STANDBY indicator
The amplifier is in standby state and waits for
instruction signal from the 12V TRIGGER IN ter-
minal.

ON indicator
The main power of the amplifier is turned on and
you can play and enjoy an input source.

Notes:
• If the POWER switch is pressed and both of the ON

and STANDBY indicators do not light, check that the
power cord is properly connected. If the indictors still
do not light, turn off the amplifier, disconnect the
power cord from wall outlet, and contact your Onkyo
dealer.

• If the STANDBY indicator flashes red, the protection

circuitry of the amplifier has activated. The protection
circuitry activates if a problem such as a speaker cable
shorting or excessive temperature occurs. Turn off the
amplifier, remove the cause of the problem, and then
turn it back on. If the problem is still not solved, turn
off the amplifier, disconnect the power cord from wall
outlet, and contact your Onkyo dealer.

Front Panel