Onkyo HTP-L50 - Manual (Page 6)

6
For safety reasons, do not turn on any devices or components
until you have completed all wiring procedures.
■ Connecting the satellite speakers
Note:
The nominal impedance of this speaker system is 6
Ω
. Use
only amplifiers capable of handling this impedance.
Connecting the speakers
R
SPEAKER LEVEL
INPUT
FROM
AMP/RECEIVER
AUTO STANDBY LINE
INPUT
L
R
OFF ON
OUTPUT
TO SPEAKERS
(MONO)
+ _
L + _
R +
_
L +
_
AC INLET
DIGITAL
OPTICAL
VIDEO OUTPUT
AM FM 75
S VIDEO VIDEO COMPONENT
ANTENNA
IN
Y PB PR
OUT
ANTENNA PREOUT
SUB WOOFER TV/LINE MD/CDR/TAPE
AUDIO REMOTE
CONTROL
IN IN OUT
L
R
SURROUND SPEAKERS FRONT SPEAKERS CENTER R L R L
PREOUT
SUB
WOOFER
AUDIO
(Supplied pin-cord)
■ Connecting the subwoofer
When used together with an AV amplifier or receiver with
surround playback capabilities, be sure to connect its SUB
WOOFER PREOUT terminal to the subwoofer SL-105 using
the supplied pin-cord.
If you connect the subwoofer SL-105 using speaker cables,
depending on the settings at the AV amplifier or receiver, bass
signals may be cut for an unsatisfactory bass output. For more
details regarding connection procedures, refer to the manuals
that came with your AV amplifier or receiver.
AC INLET PREOUT
SUB WOOFER TV/LINE MD/CDR/TAPE DIGITAL
OPTICAL
VIDEO OUTPUT
AUDIO REMOTE
CONTROL
AM FM 75
SURROUND SPEAKERS FRONT SPEAKERS CENTER R L
S VIDEO VIDEO COMPONENT
ANTENNA
IN
Y PB PR
IN IN OUT
L
R
R L
OUT
ANTENNA
SURROUND
SPEAKERS FRONT SPEAKERS
CENTER R L R L
MODEL D-L1
MODEL D-L1 MODEL D-L1
MODEL D-L1 MODEL D-L1 (RED)
(GRY) (BLU)
(GRN) (WHT)
Center
speaker
Front right
speaker
Front left
speaker
Surround right
speaker
Surround left
speaker
White
Blue
Red
Green
Gray
• Connect the input terminals on the rear of the satellite
speakers to the speaker output terminals on the AV
amplifier or receiver using the supplied speaker cables as
shown in the diagram to the left.
• Each speaker cable should be connected to the speaker
terminal of the same color.
The speaker’s terminals are colored as follows.
Front left speaker (+) : white
Front right speaker (+) : red
Center speaker (+) : green
Surround left speaker (+) : blue
Surround right speaker (+) : gray
Notes:
• Make sure that the positive (+)
and negative (–) speaker cables
do not contact each other. If they
do, a short-circuit may occur,
causing damage to the amplifier.
• Be sure to connect the speaker cables with the correct
polarity (+ and –) and with the proper left-right speaker
orientation. If connected incorrectly, the resulting sound
space with sound unnatural.
• Pull the speaker cable lightly to ensure that it is connected
firmly.
Connecting to the speaker terminals
Push down the lever. Insert the
exposed wires
into the hole. Release the lever.
Strip off the end of the
speaker cable insulation. Twist together the exposed
wires strands.
Before connecting
Prepare the supplied speaker cables as shown below.
Connect the SUB WOOFER PREOUT terminal on your AV
amplifier or receiver to the subwoofer rear panel using the
supplied pin-cord as shown in the diagram above.
Note:
If the amplifier has a subwoofer terminal, since its output is
monaural, connect it to the low level LINE INPUT L(MONO)
terminal on the subwoofer SL-105.