OpenBrain Wireless USB Adaptor 303W User Manual
Page 10
OPEN303W
User Guide
10
Field
Definition
Please ask your network manager about the currently used security protocol, if 802.1x
authentication is currently used, then you can check this item to enable 802.1x security
protocol. The key value will be configured automatically, just click Apply to take effect.
WPA Encryption
Setting
Protocol - This panel enables you to select an authentication protocol.
User Name - Type in the user name assigned to the certificate.
Password - This panel is available when EAP-TLS is not selected (either MSCHAP V2 over
PEAP is selected with WEP or LEAP is selected for CCX). This panel enables you to enter a
login name and password or request that the driver prompt for them when you connect to a
network.
Passphrase - Enter the key that you are sharing with the network for the WLAN connection.
Key Format - Select Hex if you are using hexadecimal numbers (0-9, or A-F).
Select ASCII if you are using ASCII characters.
Certificate - Please ask your network manager about the certificate, select the same certificate as the
certification server.
Load
You may select already saved file from the Profile name list, and then press Load. The
setting status will then be restored.
Save Current
You may save current setting to profile and add one new item in Profile name.
Delete
Delete the files in the Profile name.
Advanced
Setting
Click the Advanced Setting button to configure the following figure. Refer to the Advanced
Setting section on the next page to see more information about the Advanced Setting.
Information
Click the Information button to display the Driver Version, Utility Version and MAC Address
of the system.
Advanced Setting
User Interface
Power Consumption Setting
Field
Definition
Language Select English or Traditional Chinese.
Field
Definition
Continuous
Access Mode
(CAM)
When this mode is selected, the power supply will be normally provided even when there is
no throughput.
Maximum
Power-Saving
Mode
When this mode is selected, this device will stay in power saving mode even when there is
high volume of throughput.
Fast Power-
Saving Mode
When this mode is selected, the power mode will switch between CAM and Maximum
Power-Saving Mode depending on the volume of throughput. The device driver checks the
total bytes (only data frame) every 4 seconds to decide the power mode. If the total bytes
sent exceed 10k bytes, the device driver will choose “CAM”. If the total bytes are less than
10k bytes, however, the device driver will choose “Maximum Power-Saving Mode”.