Onkyo TX SR507 - Manual (Page 34)

34
Connecting the AV receiver
—Continued
■ If Your iPod Supports Video:
Connect your RI Dock’s audio output jacks to the
AV receiver’s CBL/SAT IN or VCR/DVR IN L/R
jacks, and connect its video output jack to the AV
receiver’s CBL/SAT IN or VCR/DVR IN V jack.
■ If Your iPod Doesn’t Support Video:
Connect your RI Dock’s audio output jacks to the
AV receiver’s TV/TAPE IN L/R jacks.
Note:
When UP-A1 series Dock that seated iPod is connected, the power consumption on standby mode slightly increases.
Connecting an RI Dock
Not all iPod models output video.
For information about which iPod models are
supported by the RI Dock, see the RI Dock’s
instruction manual.
L
R
IN
CBL/SAT
V
CBL/SAT
L
R
IN
IN
VCR/DVR
VCR/DVR
V
V
CBL/SAT
IN
Connect one
or the other
L
R
IN
TV/TAPE
Notes:
• Enter the appropriate remote control code before using the AV receiver’s remote controller for the first time (see
page 85).
• Connect the RI Dock to the AV receiver with an cable (see page 35).
• Set the RI Dock’s RI MODE switch to “HDD” or “HDD/DOCK”.
• Set the AV receiver’s Input Display to “DOCK” (see page 44).
• See the RI Dock’s instruction manual for more information.
Connecting a Dock with the Universal Port connector