Optoma Optoma Pico PK102 - Manual (Page 4)

4
2
1
1. Remove protection cap and insert
the plug. (~)
2. Connect the charger. (~)
3. During charging the LED indicator
lights red. ()
Projector will not charge while
operating.
4. The LED Charge Indicator will go off
when battery is fully charged. This
process may take up to 2.5 hours
4
VGA \ U
SB IN
DC IN
5
C
hargIng the
B
attery
VGA \ U
SB IN
DC IN 3
AV IN
FOCUS
1
2
AV IN
FOCUS
1
2
c
onnect
i
nput
s
ource
- (v
IDeo In
)
AV IN
FOCUS
1
2
iPod
VOLUME CONT
ROL
AV IN
FOCUS
1
2
VOLUME C ONTROL
or
or
or
1. Connect the AV input source.
(~)
2. Connect to external speaker using
AVII cable (optional) and use the
toggle to disable/enable the PK102
internal speaker (  )
1. All other brand and product names are
trademarks or registered trademarks of their
respective companies.
2. The connecting cable of video output
device is not supplied, please contact their
service center.
3. iPod nano/iPod touch/iPhone/iPod classic
(version 5 and above)
4. Designed for iPod/iPhone/Mobile phone/
PMP with TV out functions. Using with
device with audio signal voltage > 0.3Vrms
is not recommended.
c
onnect
i
nput
s
ource
- (vga/uSB/c
omponent In
)
VGA \ U
SB IN
DC IN
1
2
VGA \ U
SB IN
DC IN
1
2
MOLEX
VGA \ U
SB IN
DC IN
1
2
VGA \ U
SB IN
DC IN
1
2
or
or
1. Connect the VGA/USB/
Component source device.
Insert universal connector
with arrow mark facing up.
1. For more LED indicator, see page 7.
2. The indicator will flash red when no
battery is installed.
c
onnect
i
nput
s
ource
D
ata tranSfer
USB device: Support USB Flash Drive up to
5V/150mA, but does not support USB Hard
Disk Drive
Supported Files
Photos: bmp, jpeg
Video: M-JPEG, MPEG4, RMVB, RM, WMV,
Xvid, Mov by Optoma Video encoder
The laptop/PC can only detect
the input source when the PK102 is switched
on. This should stop the projection at the mean
time.
Supported formats
Component input resolution must be 480i/p
Supported formats
VGA: 640x480@60Hz, 800x600@60Hz
1. Connect laptop or PC for data
transfer to the PK102 internal
memory using supplied Male USB
Cable
The PK102 can also be charged via USB to
DC cable (  )
VGA \ U SB IN
DC IN
MOLEX
MOLEX