Oricom TCR10 - Manual (Page 8)

4.5 Using the telephone
The TCR10 telephone is used like any conventional telephone and works with all
modern telephone exchanges using the tone dialling system.
1. Lift the handset and wait until you hear dial tone. The keypad will illuminate.
2. Dial the required telephone number.
3. If the handset volume is too quiet or too loud, you can adjust this to suit your
requirements. The volume can be adjusted with the
+
and
-
volume buttons
on the handset.
4. To end the call, replace the handset.
Note: For your comfort whenever you use the telephone, the radio will mute
automatically. When you finish a call, the radio will resume.
5 Storing telephone numbers
You can store 10 numbers in your telephone. These 10 additional numbers can be
stored under the speed dial buttons. The numbers 0 to 9 on the keypad are used
as speed dial buttons.
5.1 Saving numbers under the speed dial buttons
1. Lift the handset.
2. Press the STORE button.
3. Press the MEM button.
4. Now select a speed dial storage location by pressing a number between 0 and
9 on the number pad.
5. Enter the required telephone number with a maximum of 21 digits using the
number pad.
Note: If you enter the wrong number, you can break off the process at this
point by replacing the handset.
6. Press the STORE button.
7. Replace the handset to complete the save procedure.
Tips on storing numbers:
To erase a stored number simply store a new number in the storage location that
you want to erase.
8