Oricom TCR10 - Manual (Page 10)

6 For use on a Phone System only (PBX)
6.1 Pause function when using phone on a PBX
Note! Inserting a pause between the code for the outside line (usually 0 or 9)
and the number to be dialled described in this chapter is only necessary on older
telephone systems.
With some telephone systems, there is a short pause between the code for the
outside line (usually 0 or 9) and the dialling tone. This pause can be entered when
dialling from the speed dial memories so that the following numbers are not
dialled too quickly.
Storing the pause with the number
Simply press the REDIAL button after the code for the outside line and before the
actual telephone number when storing the number. When dialling from the speed
dial memory, a pause of three seconds will be automatically inserted after the
code for the outside line.
6.2 Recall function when connected to a PBX
If you have connected your telephone to a PBX, you can use all the facilities such
as call transfer, automatic recall, etc. The RECALL button provides access to
these facilities.
6.3 PBX Message waiting indicator
The message indicator turned on the TCR10 is activated by some PBX’s. The
TCR10 offers two types of PBX message wait indication.
Use the Message Setting Switch located in the battery compartment to select
the setting to suit your PBX the default setting is OFF. Choose either Line polarity
reversal select (LR) or high DC voltage, select (HV).
10