Olympus DS-660 - Manual (Page 8)

8
Inserting Batteries
.......................................................................................................
Notes
• Be sure to stop the recorder before replacing the batteries.
Unloading the batteries while the recorder is in use may corrupt the
file. If you are recording into a file and the batteries run out, you will
lose your currently recorded file because the file header will not be
able to close. It is crucial to change the batteries once you see only
one Hash mark in the battery icon.
• Be sure to replace both batteries at the same time.
• Never mix old and new batteries, or batteries of different types
and/or brands.
• If it takes longer than 1 minute to replace dead batteries, you may
have to reset the time when you load fresh batteries (
☞ P.10).
• Remove the batteries if you are not going to use the recorder for an
extended period of time.
Inserting Batteries
1 Lightly press down on the arrow and slide the
battery cover open.
2 Insert two AAA alkaline batteries, observing the
correct polarity.
3 Close the battery cover completely.
Replacing batteries
The battery indicator on the display changes as the batteries
lose power.
When appears on the display, replace the batteries as
soon as possible.
When the batteries are too weak, the recorder shuts down
and “BATTERY LOW” appears on the display. AAA alkaline
batteries are recommended.
1
2
3
→ → →